Instructions and examples of the best traps in Minecraft. Other traps

Hello everyone, dear readers of my blog! Today I want to tell you about the traps that can be made in the game Minecraft!

The most common trap that players make is a mine. In the usual sense, we attack and explode, but in minecraft there are several types of mines.

Ordinary mine in Minecraft.

It is necessary to dig a hole in the depth of 2 blocks. At the bottom of the pit we put dynamite, on the dynamite - any block. Then we cover this block with a pressure plate. Well, and as you might guess, if you step on the plate there will be an explosion. Here is such a simple and simple mine in the world of minecraft.

Water mine in Minecraft.

It is necessary to dig the same hole as for an ordinary mine, however, pour water to the bottom, and lay dynamite on top and cover with a pressure plate. An explosion in water will not destroy any blocks, but the gripper will fall into the water - death.

You can only build such a mine in the sand, but like a simple mine - it is very noticeable for minecraft players.

Cesspool mine in Minecraft.

A pit of 4x4 blocks and a depth of 6 blocks is required. We hammer the upper level with loose blocks (gravel or sand), but so that it does not immediately fall, we set dynamite under it, and we already have a pressure plate on the loose block.

Oh yes, do not forget to install dynamite at the bottom of the pit, so that when the gripper falls into the trap and falls into the pit, it will be blown up.

A little more - the upper level of dynamite is needed in order to blow up the base of bulk blocks and "drop" the gripper into the pit where the dynamite is installed.

Honestly, this is a very difficult trap for implementation, but if you look, you can mine the entrance to your house and only you will know how to get there and not get blown up.

Mine "runner" in Minecraft.

The above mines have one serious drawback - cunning and smart grippers can run away from them. But this mine is just for such. The bottom line is that dynamite is installed at a distance of 8-12 blocks from the detonator. As a result, if the gripper did not notice the pressure plate and simply ran along it or hoped to run further from the plate (hoping that dynamite was under the plate), then he would die 100%.

The whole difficulty is that you need to do double sex. Initially, a "cellar" breaks out for a trap in which a wire of red stone is laid from the pressure plate to dynamite.

Playing online, it will be useful to learn how to make a trap in Minecraft. It can help lure a player by taking his things or protect herself and housing from griefs. Below are the best examples of simple and complex mechanisms. In Minecraft, traps are very popular, especially in games on servers.

Pit Corridor

This design is actively used for grifting at home in private. The bottom line is the construction of a narrow corridor width in one block at the entrance, which has two doors at both ends. The floor joins the sticky pistons, the control lever is located directly in the house. The first door opens with a pressure plate from the street, the second does not have one.

Use: Your task is to make the player chase after you. As soon as he passes the first door, it will close. At this time, you slam the second from the inside, after which the victim remains locked in the corridor. The point is small, use sticky pistons that push the floor back - you can make a hole below or pour lava.

Sand Stopper

How to make a trap in Minecraft that will catch mobs? Just put the sand of souls on the floor, above, at the level of human growth, place four blocks with a cross so that there is a void above the sand of souls. As soon as any monster steps on him, he will no longer be able to move, and in order to move to the next section he will have to jump, which is impossible because of the created building from above.

Against gripper

Extremely simple construction against greedy people. Make a building with a corridor in one block in the center. At the end, place the diamond cube, followed by the red torch. From him, draw a chain of red dust to the sticky pistons that control the floor - they will be activated until the gripper breaks the diamond, and with it the torch - the power source disappears and the support under your feet with it. Below it is recommended to pour lava or make a deep hole if you want to take the victim’s things.

With dynamite

An inconspicuous mechanism that can be used once, after which it becomes worthless. Dig a hole in front of the iron door. Go up and put dynamite inside it, and sand on it. Cover everything with a pressure plate supposedly designed to open the door. Indoors you can place the bait.

Result: the player who stepped on the button will start the action - dynamite will explode, sand will fall down along with the character.

Wall

This is a simple trap requiring 8 pistons and four pressure plates that need to be placed in the center, and then placed around our pistons. The bottom line is the player or mob stepping on the button activates the mechanism that creates the wall in front of it. Wherever he goes, he will not be able to get out. It is important to make a roof in order to prevent the possibility of jumping.

Diamond farm

A diamond farm is a type of bait trap. The finished structure is a building from the ceiling of which diamonds fall. Getting into the funnel located below, through distributors connected together, they again go up. The floor, as in the previous examples, is connected to sticky pistons, the walls near the funnel too - this is done to push the character if he does not stand on the boards.

Pistons and distributors are connected using red dust to each other. Thanks to the comparators, a chain is created in which, in the absence of a drop in the system, the energy supply to the floor disappears - the player picks up diamonds, each Piston returns to its original position, the person falls.

Minecraft traps are a “cheat” way to kill another player and take possession of his resources, so they are prohibited on decent servers. Despite the fact that with their help you can kill mobs, they are most often used to eliminate players, since you can get more loot from them.

If you are not familiar with these devices, and do not know how to make them, then a list of the most popular designs, as well as ways to create them, will be presented below.

Sliding Block Trap

To make it, you need to have a pressure plate, a piston, and one lava bucket in your inventory. This is the simplest design, which requires a minimum of resources, but it has a huge drawback - it requires restoration after each application.

Installation process:

  • dig a hole in front of the door (three blocks deep);
  • pour lava there;
  • on the right side we install a piston;
  • on the left side you need to leave space for the block;
      close the pit and install the pressure plate.

It acts simply: standing on the stove, the player starts the piston, which pushes the block to the left side and the victim falls down into the hot lava, in which she and her entire equipment burn out.

Sliding block trap

To make it, you will need one redstone, one knife switch, a redstone torch and two sticky pistons.

First of all, a hole is dug into which the player will fall, after which on the left side we are preparing a place for redstone and pistons. A torch is mounted at the back of the block with a knife switch, and a redstone is connected to the pistons.

When the player stands on the blocks, the owner of the house will only have to press the lever, and the victim will fall down. If suddenly some part of the process of creating a trap is not clear to you - you can watch the video with detailed step-by-step instructions.

Minecraft trap

To make it you need a bulk block and dynamite with a pressure plate.

It is installed simply: a hole is dug up, dynamite is laid, followed by a loose block, and all this is closed by a pressure plate. It works like this: when the victim approaches the door, an explosion occurs and the character flies down. As a result, he takes damage from both the fall and the explosion.

The disadvantage of this trap in Minecraft is that neighboring blocks can be destroyed by an explosion. To avoid this, the pit must be trimmed with obsidian.

Push trap

Composition:  redstone torch, pressure plate, redstone and 4 sticky pistons.

To make it, you need a pit in two blocks wide and as deep as possible. On the left we install the pistons, which are closed with the help of blocks. After them comes the door, in front of which there should be a pressure plate. After that, we connect the redstone to the pistons, and to the right of the pit we install 2 pistons so that when they are turned on, the pit is closed by blocks, and when disconnected, it opens.

At the next stage of construction, you need to pass the signal through the redstone block, install a torch, and connect it to the pistons on the right side. The result is an active torch and inactive dust.

During the construction of such a trap, an empty space will remain on the right side of the corridor, which may cause suspicion and scare away the victim. For a greater effect, you need to install an additional 4 pistons and use them, so the entire wall will move away, and this will not cause suspicion.

The construction method at first glance seems complicated, but after watching the video, you will quickly understand everything.

Trap chest

It is no secret that it is triggered at the moment when the victim is viewing the contents of the chest, and this is precisely the whole trick. The installation process is also quite simple: we put the chest in such a way that it was possible to approach it only in front, and dig a hole in front of it.

After that, on the contrary, we install a sticky piston - it should block the hole with the block when it is active. The next step is to bring the redstone to the piston so that it is constantly in the activated state. To do this, a torch is installed on the unit, from which the signal will disappear when the victim activates the chest, and this deactivates the piston.

The principle of the trap:  the victim walks up to the chest to search him, but instead of the reward, she will fall into the abyss.

Now you know how to build traps. As you can see, everything is very simple. It will take a little time and resources to build.

Articles / Guides for Minecraft | How to make a trap in Minecraft

   All about how to make a trap in Minecraft and what types of traps you can create in the game.

There are a lot of traps in Minecraft. There are traps with bait, chest traps, camouflaged traps, various types of traps using mines, the so-called lava traps, a falling room, a deadly button and many, many others. In fact, the number of traps is limited only by your ideas and the ability to implement them. In this article, we will consider only some options for traps, plus we will show you some videos on how to make a trap in Minecraft.

Trap chest

When opened, the trap chest signals this. This way you will find out that someone has crept up to you.
  To create it you need to get:

Tensioning sensor. To create it, you need to have a stick, an iron bar and boards. Recipe below:

A chest. He crafted using 8 boards and this recipe:

After receiving the chest and tension sensor, use this recipe to craft a trap chest:

Mousetrap

The essence of this trap is simple - to lock a gripper or a mob so that he can no longer roam around the territory. To create this trap, create:

4 doors. To create one door you will need 6 boards or 6 iron ingots, at your discretion. Recipe for crafting:

Pressure plate. To create it, you need 2 boards or 2 stones. Recipe below:

Having collected the necessary materials, install the pressure plate on the surface, and then arrange the doors in this order around the plate:

Then simply mask the doors, making it look like a certain corridor. When an undesirable character steps on the door tension plate, the door slams shut and he cannot get out of the trap.


  Trap "Sex with a Surprise" or Mousetrap-2

To create this kind of trap, you need to have:
  4 pistons. Previously, we already wrote how to make a piston in Minecraft.
Red stone. It is mined from red ore using a diamond or iron pickaxe.
  Pressure plate. How it is done read above.
  Eight blocks of the fence. We also have material on the site how to make a fence.

After receiving all the “ingredients”, dig a cruciform recess in a depth of two blocks and lay a red stone in the center. Install four pistons on the sides, 1 piston on each side. Here's how it should look:

Then install one intake block on each piston. On any red stone that is in the center, install any block, and a pressure plate on it. Thus, we still have 4 blocks of the fence. they need to be installed as shown in the screenshot below:

Congratulations, the mob trap is ready!

As you can see, there are enough options for traps, but the above describes only three ways to create traps. How to make an easy version of a trap, a death trap, a trap for zombies in Minecraft and other types of them, watch the video:

How to make a death trap in Minecraft

How to make the easiest trap in Minecraft!

How to make a trap for zombies + bonus Drop Saving! (minecraft) (minecraft) 1.5.2 -

Minecraft-how to make a sliding trap

Minecraft trap for noobs (or mobs)


This article is dedicated to minecraft traps. I think many are familiar with the mechanisms in the game with which you can do cool things. Traps were no exception. Undoubtedly traps are a useful thing, for sure everyone thought about building this trick. After all, with the help of them you can punish a bad player on the server, arrange for food extraction or just build a harmless trap to play a trick on a friend.

In this article, we give an example of the most useful and effective traps. They do not require a lot of materials for their construction, but they work flawlessly.

Trap No. 1

This trap will be very useful for you on the server. The essence of the trap is that when you approach the door of your house, the enemy will fall into the hatch. Of course, if you want it and press the lever. The tunnel where the enemy will fall can be dug up of any depth. It all depends on what you want: Just cripple, or that the enemy would die falling from a great height. In the second case, it will be possible to carefully go down and collect the entire inventory of the deceased. Insidiously, but offenders need to be punished.

You will need:

- 2 pcs.
  - Lever 1 pc.
  - Red dust (depending on the location of the lever).

Build a mechanism is absolutely no problem. The main role is played by the lever, pistons and naturally red dust. We dig out a hole where the enemy will fall through, install two large pistons under the door (put them at a distance of 2 blocks from each other) and close them so that they are open. In the distance between the pistons we put two blocks to your taste, the main thing is that the victim would not suspect anything. Then we bring the red dust from these pistons to the network of the lever, which will naturally be at home. That's all! The trap is ready.

Trap No. 2

You will need:

- Chest.
  - Dynamite.
  - Block conductive red dust.

Making this trap is also very easy, literally in a minute having all the necessary items. A very attractive trap will attract the attention of many curious players. It is an ordinary chest, but when opened, everything will fly into the air. Simply insert under our chest any block that conducts red dust, then under this block we put dynamite itself. When the lid is opened, dynamite is activated and detonates. Very simple and efficient trap

Trap 3

Will need:

- Dynamite 1pc.
  - Any unit 1pc.
  - Pressure plate 1pc.


This type of trap is very primitive, you can call them ordinary mines. For construction, you just need to dig 2 blocks down, put dynamite in there, on top of dynamite any block, and on the block a pressure plate. Having stepped on the stove, the victim activates dynamite under him, thereby provoking an explosion. Then you can pick up all the victim’s inventory.

I think this article came to your taste, we also recommend watching a video where you can see even more traps and instructions for building them. If you have any questions, ask them in the comments.